Figure 20: „3-Phase Power Measurement" Dialog - WAGO 750-494 Series Manual

WAGO-I/O-SYSTEM 750
750-494 3-Phase Power Measurement Module
Figure 20: „3-Phase Power Measurement" Dialog
The following buttons appear in the Home (1) ribbon:
[Disconnect]
[Snapshot]
[Settings]
[Calibration]
The buttons for the individual measured value views appear in the menu (2).
The status bar (3) displays the connection icon and IP address of the fieldbus
coupler/controller or the name of the COM port. Per phase possible error
messages are shown. These are:
• No Zero (no zero crossing)
• VoltClip (voltage override - clipping)
• CurClip (current override - clipping)
• VoltSag (high measuring error - undervoltage)
Click [Settings] to open the "Settings" dialog in which you can configure the
application and I/O module.
Manual
Version 1.2.0
Separates the fieldbus coupler/controller from the PC
Opens a "Save as" standard dialog to save all actual
measured values, I/O module settings and error messages
from the status bar (3) as a CSV file. In this dialog, enter a
file name and select a location to save the file, e.g. see
section "Appendix".
Opens the settings dialog.
Opens the calibration dialog. More information is
available from the WAGO Support.
Commissioning 81