Energy" Tab; Figure 25: "Energy" Tab - WAGO 750-494 Series Manual

WAGO-I/O-SYSTEM 750
750-494 3-Phase Power Measurement Module
8.1.4

"Energy" Tab

After entering a password, you can set or reset the energy values per phase on the
"Energy" tab. The initial password is: wago. Please change this password on first
use by clicking [Change password]. Should you have forgotten the password
deinstall and install again the application "3-Pase Power Measurement". This way
the initial password is valid again.
The I/O module registers the energy consumption and saves the values cyclically.
With [Save] and [Delete] you can save the values at any time regardless the cycle
or reset them to 0.
You can further set a specific value by choosing the energy from the list, entering
a value in milliwatt hours and [Save] it. The energy measurement starts at this set
value.
These actions are carried out immediately and cannot be undone. Therefore, the
[Save] button is disabled at the bottom of the window.

Figure 25: "Energy" Tab

Manual
Version 1.2.0
Commissioning 87