Commissioning - WAGO 750-494 Series Manual

WAGO-I/O-SYSTEM 750
750-494 3-Phase Power Measurement Module
Pos : 95 /All e Seri en (Allgemei ne Module)/Ü berschriften/Ebene 1/In Betri eb nehmen - Ü bersc hrift 1 @ 4\mod_1240901452750_21.doc x @ 31570 @ 1 @ 1
8

Commissioning

Pos : 96 /Serie 750 ( WAGO-I/O-SYST EM)/In Betrieb nehmen/Parametrier en mit WAGO- I/O-CH ECK/Parametrier en mit WAGO-I/O-CH ECK 750-0494 @ 15\mod_1367496874664_21.doc x @ 118340 @ 233333 @ 1
The I/O module latched in the bus node and wired for the measurement can be put
into operation using the WAGO-I/O-CHECK software for Windows. For that, the
fieldbus coupler/controller of the node is connected, for example, to the USB port
of a PC using the WAGO USB communication cable.
WAGO-I/O-CHECK provides the following functions:
• Graphic display of the bus node
• Display, recording and export of the process data (measured values)
• Application settings
• Settings for the measurements for each of the three phases
• I/O module settings
• Settings for saving the energy values
• Saving all settings
WAGO-I/O-CHECK
You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-
302. This CD contains all the application program files and a description.
The description is also available in the Internet at
Documentation > WAGO Software > WAGO-I/O-CHECK.
To display the bus node on the PC, use the USB communication cable to connect
coupler/controller and PC and launch WAGO-I/O-CHECK.
Manual
Version 1.2.0
Commissioning
http://www.wago.com
79
under