Installation & initial operation
4.5.4 Extension of the wireless receiver by further modules
DANGER
Risk of electric shock!
There is a risk of an electric shock if the wireless receiver has
already been connected to the 230 V network at this stage.
If the wireless receiver is energized, disconnect it from the
power supply.
Before connecting further modules to the wireless receiver, ensure
that the wireless receiver is disconnected from the power supply.
All cabling must only be carried out by a qualified electrician.
The wireless receiver "R-Con" (item No. 1150772 / 1150773) features two
control modules, each with four channels. If more than eight channels are
required, further control modules "T 2P" can be connected as follows:
Release the 12 V plug-in jumper (1) connecting the modules between
1.
which the new unit shall be placed. The control module (A) on the right
hand side and the logic module (B) are connected in illustration 18.
Remove the end piece (2) marked Ω. It is recommended to release the
2.
plug-in jumpers by carefully pulling them forward.
3
3.
Push the logic module (B) which can now be moved freely on the
mounting rail, to the right to create space for the extension module (see
illustration 19).
30
1
3
A
"R-Tronic" + "R-Con"
B
(illustration 18)
2