Temperature sensor PT1000 Contents Contents Page General information ........................4 Validity of the operating instruction ...................4 Extent of supply ........................4 Contact ............................4 Declaration of conformity ......................4 Symbols used ..........................4 Safety-related information ......................5 Correct use ..........................5 Warnings ...........................5 Safety notes ..........................5 2.3.1 Danger to life due to electric current ......................
General information Temperature sensor PT1000 General information Declaration of conformity Oventrop GmbH & Co. KG hereby declares that this The original operating instructions were drafted in product complies with the basic requirements and German. other relevant provisions of the EU Directives con- The operating instructions in other languages have cerned.
Operating safety is only guaranteed if the product is used correctly. Safety notes The temperature sensor PT1000 may be used for We have developed this product in accordance with water temperature measurement in the Oventrop current safety requirements.
Connecting cable Sensor Transport and storage Functional description Temperature 0 °C to +40 °C range The temperature sensor PT1000 is installed at 3 po- Relative air Max. 95% sitions in the fresh water stations Regumaq X-25 and humidity Regumaq X-45. Particles...
Temperature sensor PT1000 Installation Installation Replacement of the temperature sensor for the storage cylinder circuit You can find information on the construction and the designation of the components in the operating instructions of your fresh water station. WARNING Danger to life due to electric current Danger to life due to contact with live com- ponents.
Installation Temperature sensor PT1000 9. Fit the new temperature sensor. Replace the O-ring. 10. Carry out the electrical connection of the new tem- perature sensor as described in section 5.5. 10. Fit the new temperature sensor. Replacement of the temperature 11.
Temperature sensor PT1000 Commissioning 1. Carefully remove the controller from the lower shell as shown in Illust. 4. 2. Rotate the controller and secure it in the installation position as shown in Illust. 5. 3. Loosen the screw with hexalobular socket (see position (2) in Illust.
Disposal Temperature sensor PT1000 Disposal Directive 2012/19/UE WEEE: Waste electrical and electronic components (WEEE) must not be disposed of with do- mestic waste, but must be dropped off at a collection point of the recycling of electrical and electronic appliances.