Adaptation Of "R-Con" Channels To "R-Tronic" ("Teach In") - oventrop R-Tronic RT B Installation And Operating Instructions Manual

"R-Tronic" + "R-Con"

4.6.2 Adaptation of "R-Con" channels to "R-Tronic" ("teach in")

NOTE
During initial operation each channel of a control module "R-Con T 2P" has to
be adapted to a wireless thermostat individually. Always carry out the "teach in"
processes for the channels of one control module first. During the "teach in"
processes of the channels of one module, the corresponding rotary switch of the
other module (or the other modules) always has to be set to RUN.
1. Select a channel that shall be adapted at the control module by turning
the lower rotary switch for the selection of the channels (A) to the
number of the required channel (for instance "channel 1" as shown in
illustration 30). The red LED of the upper rotary switch for the controller
settings (B) will flash at regular intervals of 2 seconds.
A
2. Go to the main menu of the wireless thermostat ("R-Tronic") to which the
selected channel shall be adapted by turning the Menu-button to the
right or left until MAIN MENU will be displayed.
3. Press the Menu-button. TIME PROFILE will appear on the display.
Turn the Menu-button to the right until SETTINGS will be indicated on
the display.
4. Press the Menu-button. INSTALLATION will be displayed.
5. Press the Menu-button again. TEACH IN will appear on the display (see
illustration 31). Press the menu-button again to start the "teach in"
process. A running countdown of 30 seconds will be displayed.
Installation & initial operation
B
(Illustration 30)
39