Termination Of The Radio Communication ("Teach Out") - oventrop R-Tronic RT B Installation And Operating Instructions Manual

Installation & initial operation

4.6.3 Termination of the radio communication ("teach out")

The radio communication between a wireless thermostat "R-Tronic" and a
"R-Con" channel can be terminated via the command TEACH OUT. This might
become necessary if, for instance, two channels were mistakenly adapted to
one thermostat (see also illustration 35).
NOTE
The "teach out" process can only be carried out at the wireless thermostat
to which the channel has been adapted before.
1. Select the channel that shall be "teached out" at the control module by
turning the lower rotary switch for the selection of the channels (A)
to the number of the corresponding channel (for instance "channel 1" as
shown in illustration 30).
2. Go to the MAIN MENU of the "R-Tronic". After having pressed the
Menu-button, you will reach the submenu TIME PROFILE again. The
menu TEACH IN is reached via SETTINGS X INSTALLATION.
3. Turn the Menu-button slightly to the right and confirm the selection
TEACH OUT. As for the "teach in" process, a running countdown of
30 seconds will be displayed. The message SUCCESSFUL which will
shortly appear on the "R-Tronic" display signalizes that the "teach
out" process has been completed successfully. Now the radio
communication between the "R-Tronic" and the channel is interrupted.
The message SUCCESSFUL will be replaced by the message TEACH
OUT after about 3 seconds.
If the radio communication between further channels and the "R-Tronic"
shall be terminated, proceed as described above. The radio symbol will
disappear if no further channels can be "teached out" and the
communication with the control module was interrupted.
The tree structure illustrates the menu path for the "teach out" process:
42
"R-Tronic" + "R-Con"
(Illustration 34)