Factory Settings "R-Tronic; Restart "R-Tronic - oventrop R-Tronic RT B Installation And Operating Instructions Manual

"R-Tronic" + "R-Con"

5.4.10 Factory settings "R-Tronic"

It might be useful to restore the factory settings of the "R-Tronic" if, for in-
stance, wrong settings that do not guarantee an efficient heat control of your
room were stored by mistake. All individual settings and assignments of the
"teached in" channels of the wireless receiver will be cancelled when restor-
ing the factory settings. This is why the radio communication between the
"R-Tronic" and the wireless receiver always has to be restored (necessary
steps see paragraph 4.6).
You are in the submenu SETTINGS. Confirm the selection by pressing
1.
the Menu-button. INSTALLATION will be displayed as before.
2. Turn the Menu-button to the right and confirm the selection FACTORY
SETTINGS as well as the following selection RESTORE. If you are sure
that the "R-Tronic" factory settings shall be restored, turn the
Menu-button to the right and confirm the selection YES.
The factory settings are restored now. The date and time have to be set
X
again and any other settings must be repeated.
NOTE
If you wish to restore the factory settings of several wireless thermostats,
it is recommended to restore the factory settings of the wireless receiver
respectively control module, too, and to repeat the "teach in" process of all
channels. Please also read paragraph 4.6.4.

5.4.11 Restart "R-Tronic"

The "R-Tronic" can be restarted (for instance in case of a malfunction). Con-
trary to the reset to factory settings, all existing settings except for the date
and time will be maintained. This function is selected in the menu SETTINGS
X RESTART X YES/NO.
Operation & menu structure
73