Cabling Of The Logic Module With Burner And Pump - oventrop R-Tronic RT B Installation And Operating Instructions Manual

"R-Tronic" + "R-Con"

4.5.5 Cabling of the logic module with burner and pump

DANGER
Risk of electric shock!
There is a risk of an electric shock if the wireless receiver has
already been connected to the 230 V network at this stage.
 If the wireless receiver is energized, disconnect it from the
power supply.
 Before cabling, ensure that the wireless receiver is
disconnected from the power supply.
 Installation of the wireless receiver and cabling must only be
carried out by a qualified electrician.
Release of the burner via signal line (volt free)
Connect the control lines (A and B) to the terminal screws 3 and 4 to release
the burner (C).
NOTICE
Danger of damage to property!
Incorrect connection of the lines to the
burner may lead to damage to property.
Cabling and release of the burner must be
carried out with due consideration of the
operating instructions of the burner.
Please contact the burner manufacturer in
case of uncertainties.
Installation & initial operation
(illustration 22)
A B
C
33