oventrop R-Tronic RT B Installation And Operating Instructions Manual page 26

Installation & initial operation
Installation of supplied cable bridges (brown/blue) (230 V)
The supplied cable bridges must be installed before carrying out
cabling of electrothermal actuators. The following components must
be connected:
• R-Con N to N module N(-)
• R-Con L to T 2P-1 L(+)
• T 2P-1 L(+) to T 2P-2 (L+)
The corresponding actuator of each heating circuit has to be connected to
one of the channels of the T 2P module. A maximum of four actuators can be
connected to each of the four channels in parallel.
NOTE
Before connecting actuators to the wireless receiver, it should be specifi ed
which rooms shall have a pulse-width modulated (PWM) or two point
control as the settings of all four channels of the regulating module have to
be identical (either PWM or two point).
Further information can be found under paragraph 4.7.1.
26
blue cable bridge (not for 24V!)
brown cable bridge (not for 24V!)
brown cable bridge
R-Con T2P-1
brown
"R-Tronic" + "R-Con"
N module
T2P-2
blue
(Illustr 15)