oventrop R-Tronic RT B Installation And Operating Instructions Manual page 31

"R-Tronic" + "R-Con"
Place the extension module (C) into the upper edge of the mounting
4.
rail and push it against the rail until it clicks into position.
5. Push module B to the left until it is flush with the new module C.
6. Mount all 12 V plug-in jumpers (1) onto the free terminal blocks (3) to
connect the modules. The end piece (2) is fitted on the very right hand
side (see illustration 18).
A further control module is connected to the wireless receiver.
X
NOTE
The wireless receiver must be reconfigured when extending it by new models.
Installation & initial operation
A
A C
(illustration 19)
B
(illustration 20)
B
31