Electrical Connection Of The Wireless Receiver "R-Con" With Actuators - oventrop R-Tronic RT B Installation And Operating Instructions Manual

"R-Tronic" + "R-Con"
4.5.3 Electrical connection of the "R-Con" with actuators
DANGER
Risk of electric shock!
There is a risk of an electric shock if the wireless receiver is
connected to the 230 V network before having wired it up with the
actuators.
 Connect the wireless receiver to the 230 V network at the end,
i.e. after having carried out all cabling.
 Before cabling the actuators, ensure that the wireless
receiver is disconnected from the power supply.
 If the wireless receiver is energized, disconnect it from the
power supply.
 Installation of the wireless receiver and all cabling must only be
carried out by a qualified electrician.
For the connection of an actuator to a control module, the end or the sleeve
of the cable (A) of the actuator is inserted into a terminal screw (B) of the
module from below and is fixed with the front screw (C).
Installation & initial operation

C
B
A

(Illustration 14)
25