oventrop R-Tronic RT B Installation And Operating Instructions Manual page 40

Installation & initial operation
Press Menu-button
to start the
"teach in" process
6. The message SUCCESSFUL which will shortly appear on the
"R-Tronic" display signalizes that the "teach in" process has
been completed successfully and the following radio symbol will
be displayed:
The LED at the control module of the wireless receiver will glow red until
the lower rotary switch is set back to RUN (see note below).
Radio communication between "R-Tronic" and one "R-Con" channel
X
was created.
After about 3 seconds, the message SUCCESSFUL will be replaced by the
message TEACH IN. To adapt another channel to the same wireless thermo-
stat, turn the a.m. rotary switch to another channel (for instance "2") and start
the "teach in" process in the "R-Tronic" menu as described in step 5. Up to
8 channels (mains operation) can be adapted to one wireless thermostat.
If the next channel shall be assigned to another wireless thermostat which is,
for instance, installed in another room, perform steps 2 to 5.
NOTE
Once the "teach in" process of all channels
cabled with the actuators has been complet-
ed successfully, the rotary switch of the cor-
responding control module has to be set
back to position RUN (control operation).
Important: If the rotary switch is still set to
one of the channels in the "teach in" section
(chain symbol), a control operation is not
possible. This can be a source of error.
40
"R-Tronic" + "R-Con"
(Illustration 31)