Setting Of The Required Temperature Via Nominal Setting - oventrop R-Tronic RT B Installation And Operating Instructions Manual

"R-Tronic" + "R-Con"

4.8.2 Setting of the required temperature via NOMINAL SETTING

The room temperature cannot only be set via PROFILE ON, PROFILE OFF and
PROFILE DAY / NIGHT, but also via a direct nominal setting.
NOTE
An active heating profile will be influenced by the nominal setting for a short time.
If a heating profile with different heating and setback phases is active,
the selected temperature (nominal value) will only be effective until the
next cycle change. The same applies for cycle changes in the sequence of
programmed individual profiles (see chapter 5).
If the standard heating profile PROFILE OFF is active, the nominal value can
only be set to a maximum of 17 °C.
The required temperature for your rooms can thus be set directly via the set-
ting SET VALUE. Please proceed as follows:
1. Turn the Menu-button slightly to the left or right until SET VALUE will be
displayed.
2. Press the Menu-button. The following display will appear:
Menu-button
3. Select the required room temperature by turning the Menu-button and
confirm your selection by pressing the Menu-button once.
The message SAVED will be displayed.
The required room temperature is set now and the radiator will heat
X
according to the new setting.
Installation & initial operation
(Illustration 48)
55