Deletion Of Individual Wireless Thermostats "R-Tronic - oventrop R-Tronic RT B Installation And Operating Instructions Manual

"R-Tronic" + "R-Con"

4.6.5 Deletion of individual wireless thermostats "R-Tronic"

It is not only possible to reset all channels to factory settings (paragraph 4.6.4)
but also individual channels. This means that individual wireless thermostats
"R-Tronic" can be deleted from a control module which might be useful if an
old "R-Tronic" shall be replaced with a new one and the old device can longer
be "teached out" (for instance in case of defect).
NOTE
On principle, an "R-Tronic" which shall be replace with a new one should be
"teached out" (see paragraph 4.6.3). This way, the corresponding channel of
the control module "R-Con" will be available for a new device.
If you try to assign a new "R-Tronic" to the same channel without having
"teached off" the old device, the message CHANNEL OCCUPIED will be dis-
played. In this case, please perform the following steps:
1. Set the lower rotary switch (A) of the control module to the channel
from which the "R-Tronic" shall be deleted (for instance channel 3).
The LED of the upper rotary switch (B) will flash.
2. Turn the upper rotary switch (B) 3 times clockwise until stop within
5 seconds. The LED will flash red for 10 seconds.
Channel 3 of the control module was reset to factory settings.
X

A
B
Installation & initial operation

(Illustration 37)
45