Towing The Sprayer; Spray Filter Recommendations - Toro Multi Pro 1750 Operator's Manual

Figure 22
1. Front tie-down loop

Towing the Sprayer

In case of an emergency, you can tow the sprayer
for a short distance. However, do not use this as a
standard procedure.
WARNING
Towing at excessive speeds could cause a
loss of steering control, resulting in personal
injury.
Never tow the sprayer faster than 8 km/h
(5 mph).
Towing the sprayer is a 2–person job. If you must
move the machine a considerable distance, transport
it on a truck or trailer; refer to
(page 33).
1. Attach a tow line to the frame.
2. Put the range selector in the N
and release the parking brake.
3. Tow the sprayer at less than 8 km/h (5 mph).
g216272
2. Rear tie-down loops
Transporting the Sprayer
position
EUTRAL
Spray Filter
Recommendations
Selecting a Suction Filter
Standard Equipment: 50 mesh suction filter (blue)
Use the suction filter table to identify the screen
mesh for the spray nozzles you are using based
on chemicals products or solutions with a viscosity
equivalent to water.
Suction Filter Table
Spray Nozzle Screen Mesh
Color Code (flow Size*
rate)
Yellow (0.2 gpm) 50
Red (0.4 gpm) 50
Brown (0.5 gpm) 50 (or 30)
30
Gray (0.6 gpm)
White (0.8 gpm) 30
Blue (1.0 gpm) 30
Green (1.5 gpm) 30
*The mesh size of the suction filters in this table
are based on spray chemicals or solutions with the
viscosity equivalent to water.
Important:
When you spray with higher viscosity
(thicker) chemical products or solutions with
wettable powders, you may need to use an coarser
screen mesh for the optional suction filter; refer
to Figure 23.
Mesh size—chemical or solution viscosity
1. Higher-viscosity chemicals
or solutions
2. Lower-viscosity chemicals
or solutions
34
Filter Color Code
Blue
Blue
Blue (or green)
Green
Green
Green
Green
Figure 23
3. Screen mesh size
g214212