Installing or removing the internal VPN/IPSec module on the Secure Router 4134 73
3
Locate the internal VPN/IPSec module connector slot.
4
Holding the VPN/IPSec module by its edges, align the connector
with the slot on the Main Board, pushing down gently, but firmly,
to seat the module.
The following figure shows the location for installing the
VPN/IPSec module.
5
Using a Phillips screwdriver, tighten the two screws that secure
the module to the Main Board.
Removing the internal VPN/IPSec module
Use the procedure in this section to remove a VPN/IPSec module from the
Secure Router 4134.
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
CAUTION
The internal VPN/IPSec module is not hot swappable. Do not
open the Secure Router 4134 service access panel while the
unit is powered.
Nortel Secure Router 2330/4134
Installation — Hardware Components
--End--