Replacing The Secure Router 4134 Internal Compact Flash - Nortel Secure Router 4134 Installation Manual

86 Installing Secure Router 2330/4134 hardware components
2
3
4
5
6
7

Replacing the Secure Router 4134 internal Compact Flash

Use the instructions in this section if you must replace the internal
Compact Flash. This internal device is not hot swappable.
Using the lever on the module, pull the module straight out of the
chassis slot.
Support the module as you remove it from the chassis by
grasping it by the edges.
Ensure you place the Mediation Server Module on antistatic
material if you lay it down to install a DIMM.
Always hold the module by its edges.
Locate the DIMM to remove from the module.
Release the latches on each end of the DIMM slot.
The following figure shows the DIMM slots and the release
latches.
Firmly grasp the DIMM by its edges and pull the DIMM from the
slot.
If you are replacing the DIMM, also see
Mediation Server Module" (page
If you are not installing a DIMM at this time, replace the module
in the slot, or place a slot cover plate over the slot from which
you removed the module. Store the Mediation Server Module in
an antistatic bag until you are ready to install it in the chassis.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
"Installing a DIMM on the
83).
--End--