Installing The Internal Pvim Module - Nortel Secure Router 4134 Installation Manual

92 Installing Secure Router 2330/4134 hardware components

Installing the internal PVIM module

Use the procedure in this section to install an internal PVIM module. If
you are replacing a PVIM module, also see
module" (page
Prerequisites
•
Ensure you have a PVIM module ready to install before opening the
chassis top cover.
•
Ensure you have a Phillips #1 screwdriver.
•
Ensure the Secure Router 2330 is powered off.
Procedure steps
Step
1
2
3
4
93).
Action
Remove the Secure Router 2330 top cover. For information, see
"Removing the Secure Router 2330 top cover" (page
Locate the internal PVIM module connector slot.
See the following figure for reference.
Ensure the PVIM slot is clear of debris. Protective tape is placed
over the SO-DIMM and PVIM slots during the manufacturing
process; remove this tape if it is present.
Holding the PVIM by its edges, insert the module in the slot on
the Main Board, pushing down gently, but firmly, to fully seat the
module. The release latches close when the PVIM is properly
installed.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
"Removing the internal PVIM
--End--
88).