Installing or removing the internal PVIM module on the Secure Router 2330 95
4
Firmly grasp the DIMM by its edges and pull straight up to
remove the DIMM from the slot.
5
Insert the replacement DIMM in the slot, pushing down firmly but
gently to fully seat it in the slot.
The release latches close when the DIMM is properly installed.
Replacing the Secure Router 2330 internal Compact Flash
Use the instructions in this section if you must replace the internal
Compact Flash on the Secure Router 2330. This internal device is not hot
swappable.
ATTENTION
The internal Compact Flash that ships with the Secure Router 2330 contains
the system image.
Prerequisites
•
Ensure you have a Phillips #1 screwdriver.
•
Ensure the Secure Router 2330 is powered off.
•
Ensure you have a replacement Compact Flash ready to install.
Procedure steps
Step
Action
1
Remove the Secure Router 2330 top cover. For information, see
"Removing the Secure Router 2330 top cover" (page
2
Locate the internal Compact Flash module.
See the following figure for reference.
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
CAUTION
The internal Compact Flash module is not hot swappable. Do
not open the Secure Router 2330 top cover while the unit is
powered.
Nortel Secure Router 2330/4134
Installation — Hardware Components
--End--
88).