Installing Or Removing The Internal Scim Module On The Secure Router 2330 - Nortel Secure Router 4134 Installation Manual

Installing or removing the internal SCIM module on the Secure Router 2330 89

2
3
4
5
Installing or removing the internal SCIM module on the Secure
Router 2330
Use the instructions in this section to install, remove, or replace the
internal SCIM module on the Secure Router 2330. This internal module
is not hot swappable.
If you ordered the SCIM module with your Secure Router 2330, the Secure
Router ships with the SCIM module installed. The estimated average time
to install the internal SCIM module is fifteen minutes.
Remove the three screws securing the left-hand side of the top
cover to the chassis.
Remove the three screws securing the right-hand side bracket to
the chassis and the top cover.
Remove the three screws securing the right-hand side of the top
cover to the chassis.
Slowly slide the top cover back to take it off of the Secure Router
2330.
CAUTION
Do not open the Secure Router 2330 top cover while the unit
is powered.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
--End--