Adsl2+ Small Module - Nortel Secure Router 4134 Installation Manual

44 Nortel Secure Router 2330/4134 hardware components fundamentals
Table 28
Cable and connectors
Port Connector
10Base-T (full- RJ45
or half-duplex),
100Base-TX
(full duplex),
1000Base-T (full
duplex)
Table 29
Module LEDs
LED
10/100/1000
BASE-T PORT
STATUS
SFP PORT
STATUS

ADSL2+ Small Module

Secure Router 2330/4134 supports the following two ADSL2+ WAN
interface modules:
•
1-port ADSL2+ Annex A
•
1-port ADSL2+ Annex B
The 1-port ADSL2+ Small Modules are hot swappable interface modules.
With the hot swap feature, you can replace one module with another
module of the same type while the system is operating, without affecting
the system functionality. For information about the steps required to hot
swap Secure Router 2330/4134 interface modules, see
interface modules" (page
Recommended
cable type
EIA Category
3, 4, or 5 UTP
for 10 Mb/s
operation.
EIA Category
5 UTP or STP
required for
100/1000 Mb/s
operation.
Description
LEDs are integrated into each port.
Status of each interface:
•
Off: Link not connected or Link Fail
•
Solid Green: Link established at 10 or 100 Mbps
•
Solid Orange: Link established at 1000 Mbps
•
Blinking Green or Orange: Receiving or transmitting traffic
LEDs are integrated into each port.
Status of each interface:
•
Off: Link not connected or Link Fail
•
Solid Orange: Link established at 1000 Mbps
•
Blinking Orange: Receiving or transmitting traffic
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
Minimum
cable length
None
61).
Maximum
cable length
328 ft (100 m)
"Hot swapping