Prerequisites - Nortel Secure Router 4134 Installation Manual

62 Installing Secure Router 2330/4134 hardware components

Prerequisites

•
You must save your configuration. If you do not save your current
configuration before hot swapping a module, the Secure Router
2330/4134 uses the last saved configuration. To save your
configuration, enter save local.
•
Ensure you have the replacement interface module ready to install.
Procedure steps
Step
1
2
3
4
5
6
7
8
Action
To verify that the Secure Router 2330/4134 recognizes the
interface module, enter:
show chassis
Proceed with the hot swap of the interface module if, and only if,
the interface module appears in the list of installed modules on
the Secure Router 2330/4134. If the interface module does not
appear in the list of installed modules, see Nortel Secure Router
2330/4134 — Troubleshooting (NN47263-700).
To access the configuration mode, enter:
configure terminal
To select the interface module you want to shutdown, enter:
chassis module <slot>
Do not enter a port number.
To shut down the interface module, enter:
shutdown
It can take longer for the Mediation Server Module to shut down
compared to other modules because the Mediation Server
Module must wait for the Windows Server 2003 operating system
to shut down properly.
To verify the change in status of the module, enter:
show chassis
Remove the interface module from the Secure Router
2330/4134.
Move the cables from the module you removed to the
replacement module.
You must connect each cable in the same port on the
replacement module that the cable occupied in the module you
removed.
Insert the replacement interface module in the slot, securing it
firmly with the captive screws. Ensure you are in configuration
mode, then enter the following command to select the
replacement module:
chassis module <slot>
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.