Installing or removing an internal PVM on the Secure Router 4134 79
6
Install the access panel onto the Secure Router 4134.
7
Install the two screws that secure the service access panel to
the Secure Router 4134.
Removing the internal PVM
Use the procedure in this section to remove a PVM from the Secure
Router 4134.
Average time to remove a PVM: 1 minute.
Prerequisites
•
Ensure the Secure Router 4134 has the power switched off.
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure you have an antistatic bag or sheet available for the PVM that
you are removing.
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
CAUTION
The internal PVM is not hot swappable. Do not open the Secure
Router 4134 service access panel while the unit is powered.
Nortel Secure Router 2330/4134
Installation — Hardware Components
--End--