Prerequisites - Nortel Secure Router 4134 Installation Manual

Average time to replace the internal Compact Flash: 1 minute
ATTENTION
The internal Compact Flash that ships with the Secure Router 4134 contains
the system image.

Prerequisites

•
Ensure you have a replacement Compact Flash ready to install.
•
Ensure you have a Phillips #2 screwdriver.
Procedure steps
Step Action
1 Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. The following figure
shows the two screws that you must remove.
2 Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
3 Locate the internal Compact Flash module.
4 Firmly grasp the Compact Flash by its edges and pull straight up
to remove it from the slot. See the following figure.
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
Replacing the Secure Router 4134 internal Compact Flash 87
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Nortel Secure Router 2330/4134
Installation — Hardware Components