90 Installing Secure Router 2330/4134 hardware components
Installing the internal SCIM module
Use the procedure in this section to install an internal SCIM module. If
you are replacing a SCIM module, also see
module" (page
Prerequisites
•
Ensure you have a SCIM module ready to install before opening the
chassis top cover.
•
Ensure you have a Phillips #1 screwdriver.
•
Ensure the Secure Router 2330 is powered off.
Procedure steps
Step
1
2
3
4
91).
Action
Remove the Secure Router 2330 top cover. For information, see
"Removing the Secure Router 2330 top cover" (page
Locate the internal SCIM module connector slot.
Holding the SCIM module by its edges, align the connector with
the slot on the Main Board, pushing down gently, but firmly, to
seat the module.
The following figure shows the location for installing the SCIM
module.
Using a Phillips screwdriver, tighten the screw that secures the
module to the Main Board.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
"Removing the internal SCIM
--End--
88).