64 Installing Secure Router 2330/4134 hardware components
Procedure steps
Step
1
2
Connecting DC power
ATTENTION
The information in this section is applicable to the Secure Router 4134 only.
Average time to install one DC power cable: 3 minutes.
Action
Insert the female end of an appropriately rated AC power cord
in the AC receptacle on the rear panel of the Secure Router
2330/4134, as shown in the following figure.
Insert the male end of the power cord in a standard 110/220 V
AC power outlet.
CAUTION
Ensure you use an appropriately rated AC power
cord only. Do not use an extension cord.
CAUTION
ESD
Always wear an ESD-preventative wrist strap when connecting
cables or performing maintenance on a Secure Router 4134.
Ensure that the wrist strap makes contact with your skin.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
--End--