Installing or removing the internal PVIM module on the Secure Router 2330 93
Removing the internal PVIM module
Use the procedure in this section to remove a PVIM module from the
Secure Router 2330.
Prerequisites
•
Ensure you have a Phillips #1 screwdriver.
•
Ensure the Secure Router 2330 is powered off.
•
Ensure you have an antistatic bag or sheet available for the PVIM that
you are removing.
Procedure steps
Step
Action
1
Remove the Secure Router 2330 top cover. For information, see
"Removing the Secure Router 2330 top cover" (page
2
Locate the PVIM module. See the following figure for reference.
3
Release the latches that secure the PVIM in the slot. There is a
release latch at both ends of the PVIM slot.
4
Firmly grasp the edges of the PVIM and pull straight up to
remove the PVIM from the slot.
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
CAUTION
The internal PVIM module is not hot swappable. Do not open
the Secure Router 2330 top cover while the unit is powered.
Nortel Secure Router 2330/4134
Installation — Hardware Components
88).