Removing A Dimm From The Mediation Server Module - Nortel Secure Router 4134 Installation Manual

Installing or removing the DIMM on the Secure Router 4134 Mediation Server Module for OCS 85
7
8
9
10
11

Removing a DIMM from the Mediation Server Module

Use the procedure in this section if you must remove a DIMM from the
Mediation Server Module.
Average time to remove a DIMM from the Mediation Server Module: 3
minutes.
Prerequisites
•
Ensure the Secure Router 4134 is powered down.
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure you have an antistatic bag or sheet available for the DIMM that
you are removing.
Procedure steps
Step
1
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
Replace the Mediation Server Module in the chassis slot by
aligning the module with the slot module guides.
Slide the module into the chassis until its connector panel
touches the chassis back panel.
Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
Ensure the lever on the module is flush with the front panel of
the Secure Router 4134.
Using a Phillips screwdriver, tighten the two captive screws to
secure the module to the chassis.
Action
Using a Phillips screwdriver, loosen the two captive screws
that secure the Mediation Server Module to the chassis. The
following figure shows the screws.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
--End--