Installing A Large Module On The Secure Router 4134 - Nortel Secure Router 4134 Installation Manual

5 Ensure the lever on the module is flush with the front panel of
the Secure Router 4134.
6 Using a Phillips screwdriver, tighten the two captive screws to
secure the module to the chassis.

Installing a Large Module on the Secure Router 4134

Install the Large Module in slots 6–7 only.
Procedure steps
Step Action
1 Using a Phillips screwdriver #2, remove the slot cover plates
from slots 6 and 7.
2 Loosen the captive screw at the top of the center slot module
guide.
3 Remove the center slot module guide. The following figure
shows the removal of the center slot guide.
4 Align the Large Module with the slot and the slot module guides
on the outside edges of the slot.
5 Slide the module into the chassis until its connector panel
touches the chassis back panel.
6 Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
7 Ensure the levers on the module are flush with the front panel of
the Secure Router 4134.
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
Nortel Secure Router 2330/4134
Installation — Hardware Components
Installing the interface modules 59
--End--