94 Installing Secure Router 2330/4134 hardware components
5
Replacing the Secure Router 2330 DIMM
Use the instructions in this section if you must replace the internal DIMM
on the Secure Router 2330. This internal device is not hot swappable.
Prerequisites
•
Ensure you have a Phillips #1 screwdriver.
•
Ensure the Secure Router 2330 is powered off.
•
Ensure you have a replacement DIMM ready to install.
Procedure steps
Step
1
2
3
If you are not installing a PVIM module at this time, replace the
chassis top cover.
CAUTION
The internal DIMM module is not hot swappable. Do not open
the Secure Router 2330 top cover while the unit is powered.
Action
Remove the Secure Router 2330 top cover. For information, see
"Removing the Secure Router 2330 top cover" (page
Locate the internal DIMM module.
See the following figure for reference.
Release the latches that secure the DIMM in the slot.
There is a release latch at both ends of the DIMM slot.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
--End--
88).