4
5
Installing or removing an internal PVM on the Secure Router 4134
Use the instructions in this section to install, remove, or replace the
internal Packetized Voice Module (PVM). This internal module is not hot
swappable.
ATTENTION
You cannot enable the management port on the rear of the Secure Router 4134
(Ethernet 0/0) if you have a PVM installed (this is related to hardware design).
Ensure you use Ethernet 0/1, 0/2, 0/3, or 0/4 for management if you use a PVM
in the router.
If you ordered the PVM with your Secure Router 4134, the Secure Router
ships with the PVM installed.
Average time to replace the internal PVM module: 2 minutes.
Installing or removing an internal PVM on the Secure Router 4134 75
Grasping the edges of the VPN/IPSec module, pull the module
up and out of the slot in which it is seated.
If you are not installing a VPN/IPSec module at this time, replace
the service access panel.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
--End--