Nortel Secure Router 4134 Installation Manual page 77

Installing or removing an internal PVM on the Secure Router 4134 77
4 Ensure the PVM slot is clear of debris. Protective tape is placed
over the SO-DIMM and PVM slots during the manufacturing
process; remove this tape if it is present.
5 Holding the PVM by its edges, insert the module in the slot on
the Main Board, pushing down gently, but firmly, to fully seat the
module. The following figure shows the proper orientation of the
PVM in relation to the slot. If you are looking at the rear of the
router (with the service access panel removed), the key of the
PVM is on the left side.
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.