74 Installing Secure Router 2330/4134 hardware components
Prerequisites
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure the Secure Router 4134 has the power switched off.
•
Ensure you have an antistatic bag or sheet available for the
VPN/IPSec that you are removing.
Procedure steps
Step
1
2
3
Action
Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. Remove these two
screws only. See the following figure.
Slide the access panel toward you until it is clear of the Secure
Router 4134.
Remove the two screws that secure the VPN/IPSec module to
the Main Board (see the following figure).
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.