Nortel Secure Router 4134 Installation Manual page 45

You can install the 1-port ADSL2+ Small Modules in any of the Small
Module slots on the Secure Router 2330/4134 chassis. The following
figure shows the 1-port ADSL2+ Annex A Small Module.
Figure 24
1-port ADSL2+ Annex A Small Module
The following figure shows the 1-port ADSL2+ Annex B Small Module.
Figure 25
1-port ADSL2+ Annex B Small Module
The following table lists the connectors and cables to use with the 1-port
ADSL2+ Small Modules.
Table 30
Cables and connectors
Port Connector
ADSL2+ RJ11
ATTENTION
Ensure that you use straight cables with ADSL2+ modules. The TIP must
connect to TIP and RING must connect to RING.
The following table describes the LED status for the 1-port ADSL2+ Small
Modules.
Interface modules for the Secure Router 2330/4134 45
Recommended cable
type
24 AWG Category 5
twisted pair cable
Nortel Secure Router 2330/4134
Installation — Hardware Components
NN47263-301 03.01 7 September 2009
Copyright © 2007-2008 Nortel Networks. All Rights Reserved.
Minimum cable
length
—
Loop length
17000 ft (5180 m)