Table of Contents
Advertisement
262
Radix User's Manual
A-6 -
A-8
These three switches determine the default interna-
tional character set as shown in Table
H-2.
These
switches are all set ON at the factory.
Table H-2
Intemationd
chamcter sets
Switch
USA
England Germany Denmark France Sweden
IaY
A-8
ON
OFF
ON
OFF
ON
OFF
ON
A-7
ON
ON
OFF
OFF
ON
ON
OFF
A-8
ON
ON
ON
ON
OFF
OFF
OFF
Spain
OFF
OFF
OFF
c-1
c-2
c-3
C-4
This switch disables the paper-out sensor. If this
switch is ON the printer will signal the computer
when it runs out of continuous paper and will stop
printing. If this switch is OFF the printer will ignore
the paper-out sensor and will continue printing. This
switch is set ON at the factory.
This switch selects the active interface. Turn this
switch ON to use the serial interface. Turn this
switch OFF to use the parallel interface. This switch
is set OFF at the factory.
This switch controls the eighth bit of the parallel
interface. If this switch is ON the printer will only
read the first seven bits on the parallel interface and
ignores the eighth bit. If this switch is OFF all eight
bits will be read. This switch is set OFF at the factory.
When this switch is ON, Radix will automatically
advance the paper one line every time it receives a
carriage return. When this switch is OFF, the corn-
puter must send a line feed command every time the
paper is to advance. (Most BASICS send a line feed
with every carriage return, therefore, this switch
should usually be off.) This switch is set OFF at the
factory.
Advertisement
Table of Contents
