Star Micronics Radix User Manual page 24

-
10
Radix User's Manual
3. pull the release lever towards you to put it in the "tractor" posi-
tion.
4. Pull the bail lever towards you to the open position.
5. Onen the tractor covers, located on top of the left- and right-
-- hand sprocket units (Figure l-7).
-
Figure 1-7.
The tractors, which guide the paper, are underneatn tne rear cover.
.
-
.-
-,
-.
6. Flip the sprocket clamp levers towards the rear. This unlocks
the sprocket wheels to move left and right so you can align them
with the holes in the paper.
7. Bring the paper up from the back, over the wire guide, and into
the back of the printer. When the holes in the paper fit snugly
over the nubby teeth in both sprockets, close the tractor covers
and snap the clamp levers back into their locked positions (Fig-
ure l-8).
8. Now we'll feed the paper around the platen automatically To do
this, close the rear cover, turn on the power, then push the
--