Star Micronics Radix User Manual page 197

Setting Up Radix
183
same way. To remove them, lift up the free end (nearest the center
of the printer) so that the cover makes approximately a
45O
angle
with the printer frame, then with a slight rocking motion, lift it
straight up and off the machine. To replace, just reverse the proce-
dure. Figure A-2 illustrates the proper position and movement for
both removal and replacement of the covers.
R/ear cover
Figure A-2.
Remove the printer covers by tilting them up to about
45O,
then lifting
straight up.
Removing packing and shipping scmws
There are three (on a Radix-lo) or four (on a Radix-15) ship-
ping screws on the bottom of the printer, used to hold the internal
chassis securely to the external frame during shipping. To get at
these, carefully place the printer upside down on a soft surface
like a foam cushion. Remove the screws with a Phillips screw-
driver as shown in Figure A-3.
Next, remove the front cover, and remove the large flat piece
of cardboard packing which protects the print head, per Figure
A-4.