Table of Contents
Advertisement
186
Radix User's Manual
1.
Turn the power switch off, and remove the front cover (as
explained earlier.)
2. Slide the print head gently with your fingers to the approximate
center of its pathway.
Guide pin
-
.-
-
Figure A-5.
A guide pin on each side of the ribbon cartridge helps to align the
cartridge during installation.
-
-
3. Note the position of the guide pins on the cartridge as shown in
Figure A-5. Then hold the cartridge at each end, with the ribbon
facing away from you, and insert the guide pins into the cut-out
hooks of the printer frame. You'll find this easier if you tilt the
cartridge forward as you do this, as Figure A-6 shows.
4. Using the guide pins as a fulcrum, lightly press the cartridge
down until the two holder springs snap shut to hold the car-
tridge firmly in place.
5. Now thread the ribbon carefully between the print head and the
ribbon guide next to the platen, (Take a good look at
-
-
-
-
Advertisement
Table of Contents
