Table of Contents
Advertisement
174
Radix User's
Manual
6. Remove the wrapping from the new ribbon sub-cassette,
removg the adhesive tape attached to the joint, and insert the
sub-cassette into the ribbon cassette as shown in Figure 14-2.
7. Pull out the ink ribbon and set it according to the directions
shown by the arrow in Figure 14-3. It's easy for the ribbon to
get twisted somewhere along its pathway. Don't let it happen!
'igure
143. Make sure that the ribbon is not twisted when you thread it through its
path.
-
8. Firmly pull the idler gear towards you and guide the ribbon
between the idler gear and the ribbon drive gear.
9. Remove both top and bottom of the ribbon sub-cassette.
10. Replace the ribbon cartridge top cover.
11. When you've completed the installation, mark the correct
number on the silver label stuck on the right-hand side of the
cartridge cover. This number indicates the number of times
the ribbon has been replaced. Five replacements is the maxi-
mum, after which you should buy a complete new cartridge.
Advertisement
Table of Contents
