Change Of The Carburetor Main Jet - Rotax 125 MAX DD2 evo Installation Instructions And Operators Manual

CHANGE OF THE CARBURETOR MAIN JET

To change the carburetor main jet, proceed as follows:
Tools required:
• Open-end wrench 19 mm
• Flathead screwdriver
NOTE
The carburetor must not be removed from the engine in order to change the
jetting.
When handling with fuel, do not smoke or allow open flames. Gasoline and gasoline va-
ENVIRONMENTAL NOTE
Don't spill fuel. Absorb spilled fuel with appropriate drying agent and ensure ecological
Effectivity: 125 MAX DD2 evo
BRP-Rotax
Operators Manual
Non-compliance can result in serious injuries or death!
Handle fuel in well-ventilated areas only.
Non-compliance can result in serious injuries or death!
por are highly flammable and explosive under certain conditions.
Make sure that fuel will not splash onto hot engine components or equipment.
Step Procedure
1 Drain the fuel in the float chamber into a suitable clean tray by removing the
plug screw (pos. 27) and gasket ring (pos. 26).
NOTE
The fuel drained from the float chamber may be poured back into the
fuel tank.
2 Remove the main jet (pos. 15) and the main jet cup (pos. 14).
NOTE
The size of the jet is imprinted on the face of the main jet.
m WARNING
m WARNING
m WARNING
Risk of fire and explosion!
disposal.
3
Page 11
Edition: September 01 2019