Rotax 125 MAX DD2 evo Installation Instructions And Operators Manual page 59

CHECK OIL LEVEL IN GEARBOX
The gearbox is already filled with the appropriate
amount of oil by the engine manufacturer. However,
before the engine is installed in the frame, the oil lev-
el must be verified or replenished.
Step Procedure
1 Place engine on a horizontal surface
and/or assembling trestle.
ATTENTION
When placing the engine on a horizontal sur-
face, take care not to damage the crankcase
sensor, which is mounted on the bottom of the
crankcase.
Step Procedure
2 The oil level can be checked on in-
spection glass (pos. 1). It should reach
approximately to one-third of the in-
spection glass, see following figure. If
the oil level is not sufficient, replenish
oil as described in the following steps.
NOTE
For gearbox oil specifications and oil capacity
(total) see the latest Operators Manual.
7
Page 2
Edition: September 01 2019
BRP-Rotax
INSTALLATION MANUAL
Figure 8.1
1
Step
Figure 8.2
1
Inspection glass
Procedure
3 Remove the air vent screw (pos. 1)
and slowly fill in oil until oil level is in
the middle of the inspection glass.
4 Hand-tighten air vent screw (pos. 1).
Air vent screw
Effectivity: 125 MAX DD2 evo