Rotax 125 MAX DD2 evo Installation Instructions And Operators Manual page 54

Figure 7.17
1 Bowden cable
3 Guidance
Step Procedure
9 Install Bowden cables (pos. 1) into the
support on the back of the engine.
Figure 7.18
1 Bowden cable
Step Procedure
10 Thread both ends of the Bowden ca-
bles (pos. 1) through the cable support
(pos. 2). Install the set screw (pos. 3)
onto the cable support – just pre-as-
semble it, do not tighten yet.
Effectivity: 125 MAX DD2 evo
BRP-Rotax
INSTALLATION MANUAL
2 Retaining plate
Figure 7.19
1 Bowden cables
3 Set screw
Step Procedure
11 Hand-tighten both Bowden cables
(pos. 1) onto the control whip (pos. 2),
using M6. Allen screws (pos. 3) and
washers (pos. 4). Pay attention to the
correct installation of the control whip!
NOTE
The oblique millings (pos. 5) of the control whip
serve to guide the cables. The cable ends must
look away from the center of the control whip.
The Bowden cables can be attached to the control
whip in two different ways:
• Version 1:
Fasten Bowden cable to position 5 inside.
Feature: Shift travel longer, but less effort.
• Version 2
Fasten Bowden cable to position 5 outside.
Feature: Short shift, but higher effort.
2 Cable support
Page 9
Edition: September 01 2019
6