Rotax 125 MAX DD2 evo Installation Instructions And Operators Manual page 23

INSTALLATION OF THE BOWDEN
CABLE FOR CARBURETOR
CONTROL
Tools required:
• Open-end wrench 10 mm
Step Procedure
1 Carefully remove carburetor cover with
rubber ring (pos. 7, 8).
ATTENTION
Reset spring of carb piston presses against
carburetor cover and might eject carburetor
cover at removal.
Step Procedure
2 Remove nipple screw (pos. 5) with
open-end wrench 10 mm from carbu-
retor piston (pos. 2).
3
Engage nipple of Bowden wire (pos. 9)
in nipple screw (pos. 5).
4 Fit nipple screw in carburetor piston
and hand tighten with open-end
wrench 10 mm.
5 Insert carburetor piston (pos. 2) into
carb body with recess of piston to-
wards intake silencer.
6 Pass Bowden wire through compres-
sion spring (pos. 6) and through cover
with rubber ring (pos. 7, 8) of
carburetor.
7
Fit carb cover (pos. 7) on carburetor.
8 Pass Bowden wire through Bowden
conduit and through adjustment screw
on chassis (throttle pedal).
9 Connect Bowden cable to throttle
pedal.
2
Page 4
Edition: September 01 2019
BRP-Rotax
INSTALLATION MANUAL
Figure 3.5
1
3
5
7
9
NOTE
Shorten Bowden cable as required.
Step
10
2
Carburetor
4
Jet needle K57
Nipple screw 6
8
Carb cover
10
Bowden cable
Procedure
Route carburetor Bowden cable on the
top side of the chassis tubes and at-
tach with the cable ties supplied. Make
sure that the Bowden cable does not
touch any moving parts or the track.
Effectivity: 125 MAX DD2 evo
Carburetor piston
Clip
Compression spring
Rubber ring
Restrictor (Mini, Micro
MAX evo)