Rotax 125 MAX DD2 evo Installation Instructions And Operators Manual page 56

Figure 7.23
1 Allen screw M6x60
Control whip
3
Step Procedure
15 Place the entire shifting unit onto the
steering wheel and tighten it using Al-
len screw M6x 60 (pos. 3), M6 lock nut
(pos. 1) with washer (pos. 2).
NOTE
Control whip must run smoothly.
NOTE
Spacer must fit into the bore provided on the
steering wheel.
Effectivity: 125 MAX DD2 evo
BRP-Rotax
INSTALLATION MANUAL
2 Washer
Figure 7.24
1 Lock nut M6
3 Allen screw M6x60
Step Procedure
16 The setting of the shifting is carried out
in neutral gear, which means that the
control whip must be in horizontal
position.
17 Tighten screw (pos. 2) of the cable
abutment (pos. 1) and the screws of
the Bowden cables on the control whip
(pos. 3).
NOTE
At full steering angle, no gear must engage. If a
gear engages by itself, the distance between
control whip and cable abutment must be
adjusted.
Step Procedure
18 Finally, the length of the Bowden ca-
bles can be adjusted so that they do
not disturb the driver when shifting.
2
Washer
Page 11
Edition: September 01 2019
6