Rotax 125 MAX DD2 evo Installation Instructions And Operators Manual page 55

Figure 7.20
1 Bowden cable
3 Allen screw
Oblique millings
5
Step Procedure
12 Hand-tighten control lever left and right
(pos. 1) onto the control whip (pos. 4),
using M6 Allen screws (pos. 2) and
washers (pos. 3).
Figure 7.21
1 Control lever
3 Washer
6
Page 10
Edition: September 01 2019
BRP-Rotax
INSTALLATION MANUAL
2 Control whip
4
Washer
2
Allen screw
4 Control whip
NOTE
The control lever can also be attached on the
back, depending on how it is more ergonomic
for the driver.
Procedure
Step
13 Install spacer (pos. 1) with washer
(pos. 2) onto the bottom side of the
control whip (3).
NOTE
The bottom side is, where the screws of the
Bowden cables are fixed.
Figure 7.22
Spacer
1
Control whip
3
Procedure
Step
14 Tighten Allen screw M6x60 (pos. 1)
and washer (pos. 2) onto the top of the
control whip (pos. 3).
NOTE
Top is the opposite side, where the screws of
the Bowden cables are attached.
2
Thrust washer
Effectivity: 125 MAX DD2 evo