Table of Contents
Advertisement
Figure 8-2 Standard Mode Signal Type Selection
Standard Mode is mostly used when using a single reference for switching different signals
within the frame. A common example is when switching both standard SD and HD formats
based on the same sync input. This feature allows Platinum not to require a Tri-Level HD
reference to switch at the correct place within the signal even when using a standard
'House Black' reference.
Example Configuration
House Black NTSC Reference when switching both SD (NTSC) and HD (1080i 59.9) signals.
1
Attach House Black sync reference to both sync 1 and sync 2 inputs on the back of the
frame.
2
In Navigator or RouterMapper, navigate to the Platinum Control Settings tab, and then click
the Change Sync Settings Sync... button.
The Configure I/O Sync dialog box opens.
3
Set Sync 1 switch configuration to Auto (should be configured already by default).
Platinum Frames and Modules
Installation, Configuration, and Operation Manual
399
Advertisement
Table of Contents
