Table of Contents
Advertisement
Back Panel I/O Module for PM-SR-OBG+/PT-SR-OBG
The PT-V-BP back panel I/O module corresponds to the PM-SR-OBG+ and PT-SR-OBG+
modules.
Submodules
PT-MX-SB
The optional PT-MX-SB submodule corresponds to the PM-SR-OBG+ and PT-SR-OBG+
modules. See page 285 for more information.
Note: Modules marked as PM-SR-OBG+DX are PM-SR-OBG+ modules equipped with
PT-MX-SB submodules. Modules marked as PT-SR-OBG+DX are PT-SR-OBG+ modules
equipped with PT-MX-SB submodules.
Installation
Output Module Installation
All output modules are installed at our manufacturing facility. See
Information for Upgrading 3 Gb Input, Output, and Crosspoint Module Firmware
on page 357 and
for field expansion or replacement of output modules. If you need to purchase additional
components, please contact your dealer or our Sales Department.
Back Panel I/O Module Installation
All back panel modules are installed at our manufacturing facility. See
Panel Modules
If you need to purchase additional components, please contact your dealer or our Sales
Department.
Configuration
This module requires no additional configuration procedures besides those described for
frame configuration.
Controllable Parameters
Table 4-14
modules. These parameters are accessible via either RouterMapper or CCS Navigator. In
RouterMapper, parameters are found in the Configure Module Parameters and/or Module
Parameters list boxes. In Navigator, when in control mode, double-click on the device name
to open a window that displays that device's parameter list.
See the appropriate reference manual for information on how to set these parameters.
Installing Input and Output Modules
on page 372 for the procedure for field expansion of back panel modules.
lists the user-controllable parameters for the PM-SR-OBG+ and PT-SR-OBG+
Platinum Frames and Modules
Installation, Configuration, and Operation Manual
Special Pre-Installation
on page 361 for the procedure
Installing Back
233
Advertisement
Table of Contents
