Table of Contents
Advertisement
388
Chapter 8
Configuration
Frame Controllable Parameters
Default Settings
3
Press Select.
The first two items in the Level One list appear.
4
Click Nav- (down) on the Nav-/Nav+ switch to view more items in the list.
5
Choose the desired item in the list, then press Select.
The Level Two list will appear.
6
Repeat steps 4 and 5 to view more items in Levels Two, Three, and Four.
7
If the parameter is numeric, slide the bar to the desired parameter using the Nav+/Nav-
switch; or, choose the desired item in the Level Four list, and then press Select.
8
Once you have set or viewed the parameter, you can leave it in its current state or return to
the card-edge display banner.
To return to the card-edge display banner, repeatedly press Escape.
9
Close the front panel of the frame to ensure the cooling system continues to operate
properly.
The card-edge controllable parameters listed below are specific to a Platinum frame. Frame
controllable parameters available through Navigator or RouterMapper are shown in
8-4
on page 394. Controllable parameters specific to a particular module are listed with the
module's detailed description.
Table 8-1 Platinum Default Settings
Item
IP address
Gateway
Subnet mask
Serial baud rate
Serial mode
Telnet
FTP
VXY Server
Default Setting
192.168.100.250
192.168.100.1
255.255.255.0
38400 baud
RS-232
On
On
On
# of users= 4
Table
Advertisement
Table of Contents
