Table of Contents
Advertisement
136
Chapter 3
Input Modules
Installation
Configuration
Controllable Parameters
The module will determine its data rate by the Input Rate parameter. The user can specify it
to be SD, 1.5HD or 3G HD. If set to Auto, the data rate is determined by the first detected
SDI signal (for example, if signals are applied to SDI 1-8, the data rate is determined by
SDI1. If SDI1 is removed, then SDI2 determines the data rate).
The PT-DMX-3G/PT-DMX will automatically bypass a specific SDI channel under the
following conditions:
No signal is detected and LOV mode is set to Pass Input
The signal is not locked to the reference and Unlocked SDI Bypass is enabled
The signal data rate does not match the module's data rate
Audio Order of Operations
1
Insert Tone (if enabled)
2
Polarity Reversal and Level Adjust
3
Sum
4
Swap/Copy
5
Mute (if enabled)
This option is not user-upgradeable. For further assistance regarding PT-DMX-3G/PT-DMX
hardware/firmware requirements and installation, please contact our Customer Service
Department.
This module requires no additional configuration procedures besides those described for
frame configuration.
Table 3-44
lists the user-controllable parameters for the PT-DMX-3G/PT-DMX submodules.
These parameters are accessible via either RouterMapper or CCS Navigator. In
RouterMapper, parameters are found in the Configure Module Parameters and/or Module
Parameters list boxes. In Navigator, when in control mode, double-click on the device name
to open a window that displays that device's parameter list.
See the appropriate reference manual for information on how to set these parameters.
Note: Because the PT-DMX-3G/PT-DMX parameter list has multiple levels,
includes a Parameter Tree column. This column indicates the parameter's location on the
Navigator parameter tree list.
Table 3-44
Advertisement
Table of Contents
